CAT IN A CUP, IRON-ON DESIGN

- 1 iron-on design

- Height of the design approx 6 cm

- Washing machine resistant (max 60°C)

- Made in Finland

- OEKO-TEX standard 100

- Design by Wilhelmiina Saarimaa / Wilhelmiina Design

You need these to attach the iron-on design:
iron-on design, clothing or another textile or fabric, iron, baking paper, hard surface (ironing board is too soft).

How to attach the iron-on design:
- Make sure that the clothing or fabric is clean and suitable for ironing.
- Set the clothing on hard surface.
- Remove the sheet from the back side of the iron-on design. (Sheet on top of the iron-on design is heat resistant.)
- Set the iron-on design on the clothing
- Set the baking paper on top of the iron-on design
- Heat the iron to 150°C (usuallu two dots)
- Now when the clothing is on top of the hard surface and the iron-on design and the baking paper are on top of it, press the hot iron on them evenly for 5 seconds. If your iron is not hot enough, the ironing time must be longer. For example 130°C = 10 seconds.
- Remove the baking paper and the sheet on top of the iron-on design gently when the iron-on design is still warm. If the iron-on design is not fully attached, put the sheet and baking paper back on it and press with the hot iron again for another 5 seconds. Repeat if needed.
- The iron-on design is fully attached when you can see the texture of the fabric on the surface of the iron-on design.

Washing instructions:
- Wash in a washing machine max. 60 °C
- These are not recommend: drum drying, strong laundry detergent, fabric softener, chemical wash, bleaching
- Turn the clothing inside out when ironing

Made in Finland

One unit = 1 iron-on design